REVO | SEAT, LEON MK3 (5F 2012 – 2020), 2.0 TSI (GPF) – 2018> | 290/300ps | ECU SOFTWARE

Revo offers some of the most substantial performance increases on the market, however, only the driven know that peak figures form part of a much bigger picture and are never the sole focus during Revo’s development process; it’s all about the drive. Only Revo offers a perfect balance of performance, economy and engine longevity.

The Revo tuning philosophy ensures that impressive performance benefits are balanced with useable, reliable power delivery that enhances the way your vehicle drives. Development on the road and racetrack as well as testing in controlled dyno conditions gives you a clearer picture of the performance you can expect from Revo ECU Software. Testing in this way plays an important role in ensuring the highest quality products and delivering the driving experience expected.

2.0TSI IS38 GEN3 GPF
The latest generation 2.0TSI engine has seen some substantial changes in factory form to keep in line with the latest emissions laws. Most notable is the introduction of the GPF (Gasoline Particulate Filter) and the change to the direct injection system. Close monitoring of the GPF system has been an essential step in finding the limitations and tuning potential of the newer DNU* engines. The general consensus is that the GPF not only mutes but limits the engine power, Revo ECU calibration might be a reason to dispute that.

Enhancing the vehicle with Revo ECU Software gives you much more than just an increase in power and torque. A large part of development is based on drive cycle and driver feedback, our calibration doesn’t just give a great dyno curve and peak power/torque figures but also delivers in feel; giving a smoother yet more responsive feel at low RPM/ partial throttle with huge gains at wide-open throttle throughout the whole rev range.

Only Revo performance ECU Software maintains factory safety levels and additional driving features. You can switch between three pre-set fuel quality modes depending on the fuel you use; these modes are set through testing our development vehicles in varying climatic conditions with a range of fuel quality throughout the world. The Revo SPS Software Switch is also available separately, can be used to quickly switch between performance modes and access the additional Anti-Theft mode.

STAGE 1 ECU SOFTWARE FEATURES:

COLD START PROTECTION
Boost is limited until safe oil temperature is reached.
…
TEMPERATURE PROTECTION
Enhanced engine cooling and oil temperature management.
…
SPEED LIMIT UNLOCK
The top speed limit for this vehicle has been removed.

STAGE 2 ECU SOFTWARE FEATURES & INFORMATION:

Rather than simply removing the GPF, and therefore making vehicles illegal for road use we have been monitoring the effects that running higher power has on them. Our Stage 2 GPF software retains the stock downpipe factory catalytic convertor and GPF 3, although we did upgrade the GPF back section on our own Seat Cupra development vehicle to give more exhaust acoustics. Through months of extensive development, we were able to produce software with similar performance to pre-GPF 2.0TSI IS38 Stage 2 vehicles.

RPM LIMIT INCREASE
RPM Limit has been increased for optimal performance.
…
LEFT FOOT BRAKING
Left foot braking has been enabled on this vehicle.
…
BRAKE BOOST
Build boost while braking.

REQUIRED HARDWARE FOR STAGE 2:
Revo Performance Pack
or
Revo Intercooler
Revo Intake System
Revo Intercooler Pipe Upgrade

RECOMMENDED HARDWARE FOR STAGE 2:
Uprated suspension
Uprated brakes
Uprated engine mounts
Clutch for manual vehicles

NOTE:
Power is dependant on Fuel Quality, Performance Settings and Conditions.

Price displayed will vary depending on and discounts may apply:
– If there is any existing ECU software on your vehicle.
– If you have exisiting Revo ECU software on your vehicle and you’re going up through the stages.

REQUIRED HARDWARE FOR STAGE 2:
Revo Performance Pack
or
Revo Intercooler
Revo Intake System
Revo Intercooler Pipe Upgrade

RECOMMENDED HARDWARE FOR STAGE 2:
Uprated suspension
Uprated brakes
Uprated engine mounts
Clutch for manual vehicles

Vehicle Fitment for this product

Please be aware, this list of compatible vehicles is taken from data provided by the supplier. It is recommended, if you’re unsure, to contact us first before placing an order.

• SEAT > Leon MK3 (2013-2020) > Leon Cupra 290 (290ps) 2018-2020
• Parts > Vehicle Tuning > Revo ECU Software

We’re providing you with an all in one, supply and fit, performance parts solution which is facilitated by our network of trusted, reputable Quattro-Tech sites across Cambridgeshire.

Any products ordered will be delivered to your chosen Quattro-Tech site at checkout for fitment.

A member of our team will be in touch with you directly, via phone or email, once you have completed your order to discuss a date and time for fitment at your chosen site location.

You will then receive an order confirmation email with the full details of your’ booking, including parts ordered, site location, date and time.

ORDER, ARRIVE AND DRIVE.

Do you have a question?

If you have a question about this product, just fill in the form below. We’ll get back in touch as soon as possible.